Analog Devices Inc. fido5100/fido5200 REM Switches

This product is available from a number of ECIA authorized distributors, click the buy now button below to compare real-time pricing and stock information
Click to purchase parts now

Analog Devices fido5100/fido5200 Real-Time Ethernet Multiprotocol (REM) Switches are designed as programmable IEEE 802.3 10Mbps/100Mbps Ethernet Internet Protocol Version 6 (IPv6) and Internet Protocol Version 4 (IPv4) switches that support virtually any Layer 2 or Layer 3 protocol.

The fido5100 REM Switch supports the following protocols:

• PROFINET real-time (RT) and isochronous real-time (IRT)
• EtherNet/IP with and without device level ring (DLR)
• Modbus TCP
• SERCOS III
• POWERLINK

The fido5200 REM Switch supports the following protocols:

• EtherCAT
• All protocols defined for fido5100

The fido5100/fido5200 switches are personalized to support the protocol used by the firmware downloaded from a host processor. These 2-port, embedded Ethernet switches can interface to any processor, including any ARM® CPU and the fido1100® Communication Controller. The host processor can implement any protocol stack by integrating it with the REM switch driver. To support fast startup and quick-connect type network functionality, the firmware is downloaded in power-up mode and contained in the REM switch driver. The fido5100/fido5200 REM Switches can be ready for network data operation in less than 4ms. These 2-port Ethernet switches also have a powerful memory bus interface that supports both 16- and 32-bit wide busses and achieve data transfer rates up to 167 Mbytes/sec.

Features

  • 144-lead CSP_BGA RoHS compliant package
  • -40°C to +85°C industrial temperature range rating
  • 3.3V input/output buffers
  • IEEE 802.3, 10Mbps/100Mbps, half and full duplex, IPv6, and IPv4 communication
  • 2 independent Ethernet ports: 1 MII and 1 RMII interface per port
  • Support for all industrial protocols
    • PROFINET Class B and Class C with fast startup (Version 2.3)
    • EtherNet/IP with QuickConnect, CIP Sync, and CIP Motion
    • Modbus TCP
    • EtherCAT
    • SERCOS III
    • Ethernet POWERLINK
  • Host interface transfer rate: 32bits per 28ns
    • Supports EtherCAT cycle times down to 12.5μs and PROFINET cycle times down to 31.25μs
  • PI Net Load Class III capable
  • DLR (supervisor and node, announce and beacon based), MRPD, HSR, PRP, shared device, controller redundancy
  • IEEE 1588 Version 2 support: ordinary clock; both peer-to-peer and end-to-end transparent clocks, raw frames, and UDP
  • 8 independent timer signals synchronized with an internal precision timer
  • 4 independently programmable timer signals for timer capture events or timer output events
  • 4 timer signals create programmable periodic waveforms synchronized to the internal precision timer
  • DCP, LLDP, DHCP, RSTP, VLAN, IGMP snooping support
  • Forwarding table with aging and learning
  • Drive LEDs for link activity

Applications

  • Industrial automation
    • Process control
    • Managed Ethernet switch

Part Searches

Here is a list of the parts mentioned in the article above, just click a part number to view the search.

Your current location is: United States
You can select a different location here:

    fido5200

Additional products to consider...