DAQ Module for Distributed Acceleration and Vibration Measurement

MonoDAQ, a company that aims to simplify the test and measurement industry, has announced the launch of its latest product, the MonoDAQ E-ACC accelerometer amplifier which the company claims will save costs and increase the accuracy of acceleration and vibration measurement by enabling the module to be placed near the sensor, eliminating the need for long analogue cabling.

 Monodaq E-ACC is a small, compact device in a robust aluminium housing consisting of analogue front end with 18 kHz alias-free bandwidth, 24 bit ADC converter with up to 40 kS/s sample rate and EtherCAT interface. The EtherCAT protocol is a key factor in enabling large distances between devices – up to 50 m node-to-node. Devices are simply daisy-chained with a single network cable that carries signal and power. Synchronization below 1 µs is ensured along a virtually-unlimited chain of MonoDAQ E-ACC devices.

 Each MonoDAQ-E device has a fully isolated front end with high dynamic performance as well as TEDS support for sensor auto-recognition.

 MonoDAQ E-ACC devices come bundled with the powerful DEWESoft software which enables engineers without specialist electronics knowledge to be able to measure their phenomena of interest – usually acceleration, force, pressure, temperature, etc. Analogue, digital, GPS and video signals can be measured in the same environment and synchronized without any customization – no programming is needed to make a high-fidelity measurement.


About MonoDAQ

MonoDAQ is a start-up Slovenian company dedicated to simplifying test and measurement tasks such as measuring acceleration, force, pressure and temperature. MonoDAQ distributed modules are placed close to the sensors, eliminating lengthy cabling and improving signal fidelity. EtherCAT communications and powerful, easy-to-use software make implementing a MonoDAQ measurement network quick, easy and low cost.

 

Leave a Comment